MSCS-9000
Modular Sample Conditioning System – Permeation Dryer Type
- Chemical resistant design, all sample gas wetted parts are PVDF or PFA Teflon family.
- Full Path Electric Heating: Heats the entire moisture-laden sample path to 80±10 ℃, keeping all gases in the system above their dew point.
- Two-stage permeation dryers to remove moisture down to -25 ℃ dew point.
- Two filters achieve 0.01 μm filtration to remove dust from the sample completely to extend the lifetime of analyzers.
- Temperature monitoring and control for heat-traced bundles and initiates an alarm if failure occurs.
- Modularized flow meter design for analyzer flow, system calibration flow, and permeation dryer purge gas flow.
- Measure water concentration by Wet-Dry-Basis Oxygen Method (optional).
- Low flow switch is optional for low flow alarm.
- Modularized solenoid valve design for zero, span, and system calibration.
- Calibrated moisture detector (set at +5 ℃ dew point) to protect the analyzer by stopping the sample pump when detected (optional).
Kinetics Product
The MSCS-9000 is a modular sample conditioning system designed explicitly for the NMHC-9000, MGA-9000 analyzers, and other third-party analyzers. Suitable for installation in a standard 19" rack or wall-mounted enclosure, its primary objective is to ensure durable operating conditions for the analyzers and provide superior protection. The MSCS-9000 integrates adjustments and monitoring capabilities for pressure, temperature, flow rate, and humidity, all consolidated within a compact housing.
Technical Specification
Model
MSCS-9000
General
Housing design
19" rack mounting (IP20) or wall mounting type (IP65/ NEMA4X)
Dimensions (H x W x D)
19" rack: 225 x 485 x 505 mm
Wall mounting: 600 x 500 x 305 mm
Weight
Approx. 30 Kg
Power supply
110 ~ 240 VAC, 50/60 Hz
Power consumption
650 VA
Gas Inlet requirements
Max. sample gas pressure at inlet to sample conditioning system
2 bar abs. (others on request)
Max. moisture content in sample gas
40 vol%
Max. sample gas temperature at inlet to sample conditioning system
180 ℃
Dust content at inlet to sample conditioning system
< 2 µm
Gas connections
Sample inlet
Outlet to analyzers
Zero and span bottle inlet
1/4" OD Fittings
Outlet to sampling probe
Dry, clean air inlet (instrument air)